- 29 -
If Other Messages Are Displayed
Message displayed on the
display screen
Error
code
ATTENTION
lamp
Causes and Troubleshooting
Reference
pages
The data will be deleted due to a
spot color order mismatch error.
Check the print cartridge
position and spot color settings,
and try to print again. To turn
off the display, press OK button
Please see HELP for details
7380 Blinking The position of the white print cartridge
is different from that specified in the
printer driver.
Printing has been stopped, and the data
was deleted.
Check the order of the print cartridge
and the Spot Color setting, then print
once again.
Press the <OK> button to delete the
display on the display screen.
-
Check Waste Toner Box
Please see HELP for details
331 Blinking The waste toner box is not set correctly.
Install the waste toner box correctly.
-
Firmware Update Error
Please retry
If network doesn’t work, please
try firmware update over USB
302 - Firmware update failed.
Follow the instructions in the message.
-
Feeder Unit Not Installed
Shut down and Install Feeder
Unit
7305 Blinking The unwinder is not installed.
Turn off the power, and then install the
unwinder.
-
Belt Unit Not Installed
Please see HELP for details
689 Blinking The belt unit is not installed properly.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Check Belt Unit
Please see HELP for details
330 Blinking The belt unit is not installed correctly.
Install the belt unit correctly.
-
Unnecessary Print Cartridge
Error
Check the position of print
cartridge lift up lever
Please see HELP for details
7398
7399
Blinking The lift up lever of the print cartridge is
not in the correct position.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Install Paper Guide
Re-set the Paper Guide
Please see HELP for details
7384 Blinking The paper guide is not set correctly.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Open Cover
Paper was pulled out
7312 Blinking Paper was forcefully extracted while
being fed.
Open the cover and if there are scraps
of paper, remove them, and then close
the cover.
-
Check Installed Paper Edge
Paper Edge Long Error
Press OK Button
Please see HELP for details
7308 Blinking The mark on the leading edge of the
paper cannot be detected correctly.
Replace the paper, and then press the
<OK> button.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Paper Width Error
Press OK Button
Please see HELP for details
7383 Blinking The paper currently being used is
different from the paper settings in the
printer driver.
Replace the paper, and then press the
<OK> button.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
To Next Page
Loading...
