- 30 -
If Other Messages Are Displayed
Message displayed on the
display screen
Error
code
ATTENTION
lamp
Causes and Troubleshooting
Reference
pages
Check Installed Paper
Paper Edge Error
Press OK Button
Please see HELP for details
7307 Blinking The mark on the leading edge of the
paper cannot be detected correctly.
Replace the paper, and then press the
<OK> button.
Press the <HELP> button, and solve
according to the guidance shown on the
Help screen.
-
Paper Detection Error
[SENSOR_ERROR]
[SENSOR_ERROR]: Detailed
information of the error will
be displayed.
7381 Blinking The paper sensor cannot correctly
detect paper.
Paper setting is incorrect or the sensors
are not set/adjusted. Or, the sensor is
dirty.
There is paper left in the printer;
remove it.
-
Check Cutter Unit
Cutter Home Position Error
Please see HELP for details
7302 Blinking The cutter unit is not installed correctly.
Install the cutter unit correctly.
-
Wait a Moment
Rebooting <[CODE]>
It may take some time to
complete this process.
- On The controller unit is rebooting. -
Shutting down
Please wait. Printer will turn off
automatically
It may take some time to
complete this process.
- Off The printer is shutting down. -
To Next Page
Loading...
