- 48 -
Printing Troubles
Symptom Cause Troubleshooting
Reference
pages
The space between labels is not
cut; the labels are cut.
The position of the cut is
misaligned.
Readjust the cutting position. User’s Guide
The leading edge of the label
and the black mark positions
are not aligned.
Labels cannot be used if the
leading edge of the label and the
black mark positions do not align.
Use labels whose leading edges
align with the black mark.
Page 106
The gap interval between labels
is different between each label.
Rolls of labels that have different
intervals between labels cannot
be used. Use rolls of labels that
have regular intervals.
Page 106
The gap interval between labels
is not from 3 to 10 mm.
A gap between labels from 3 to
10 mm can be used. Do not use
any others.
Page 106
The paper size specified in the
printer driver is different from
the paper size that is loaded.
Specify the correct paper size in
the printer driver.
User’s Guide
Paper has stopped feeding. Last of the paper was detected
during warm up while paper
was feeding.
Replace the paper with a new roll
of paper.
-
Paper is not fed, even when the
<FEED> button is pressed.
Last of the paper was detected
while feeding paper.
Replace the paper with a new roll
of paper.
-
Paper is not unloaded, even
when the <UNLOAD> button is
pressed.
Last of the paper was detected
while unloading paper.
Replace the paper with a new roll
of paper.
-
The rear edge of the paper is
skewed.
Paper is not set on the roll
shaft.
Replace the paper with a new roll
of paper.
-
To Next Page
Loading...
