Oki pro920TW - MP Tray; Face-Down Stacker; Face-Up Stacker

pro920WT User’s Guide> 28
MP TRAY
The multi-purpose tray is used for media sizes additional to those of
the standard trays, heavier media weights and special media.
The multi-purpose tray can handle the same sizes as the standard
trays but in weights up to 300 g/m². For very heavy paper stock use
the face-up paper stacker. This ensures that the paper path through
the printer is almost straight.
The multi-purpose tray can feed paper widths as small as 3in
(76.2 mm) and lengths up to 47.24 in (1200 mm). For banner
printing, recommended sizes are Letter wide, 35.43 in and 47.24 in
long and weight 128 g/m².
Use the multi purpose tray for printing on envelopes and
transparencies. Up to 100 sheets of transparencies or 25 envelopes
can be loaded at one time, subject to a maximum stacking depth of
1 in.
Paper or transparencies should be loaded print side up and top edge
into the printer.
F ACE - DOWN STACKER
The face-down stacker on the top of the printer can hold up to 500
sheets of 20 lb (75 g/m²) standard paper, and can handle paper
stocks from 17 – 57 lb (64 – 216 g/m²). Pages printed in reading
order (page 1 first) will be sorted in reading order (last page on top,
facing down).
F ACE - UP STACKER
The face-up stacker should be opened and the tray extension pulled
out when required for use. (With the face-up stacker either open or
closed, the driver setting of Face Down will successfully direct prints
to the Face-Down stacker.)
The face-up stacker can hold up to 200 sheets of 20 lb (75 g/m²)
standard paper and can handle stocks up to 300 g/m².
Always use this stacker and the multi-purpose feeder for paper
stocks heavier than 57 lb (216 g/m²).