OKM FS Future Series - Important Notes; Security Guidelines; General Notes; Surrounding Area

Introduction 9
1.2 Important Notes
Prior to using the GeoSeeker and its accessories, please read these operating instructions carefully.
These instructions give information on how to properly use this geoelectrical detector and shows
potential sources where precautions should be taken.
1.2.1 Security Guidelines
The GeoSeeker has a maximum output of 390 V and 0.5 A even if it is not present at all times. But under
some circumstances the maximum output can be present at the electrodes of the GeoSeeker. Therefor
you have to take special care when handling the electrodes:
• Do not touch any of the electrodes when measuring is in progress.
• Before replacing any of the electrodes unplug the connecting cable to isolate the electrodes from
active power supply.
• Do not initiate any measuring as long as someone is handling the electrodes.
• Instruct all your helpers and assistants concerning these security guidelines to avoid
unnecessary injuries.
1.2.2 General Notes
Being an electronic device, the GeoSeeker has to be treated with caution and care as with any electronic
device. Any failure to observe the safety precautions given or any use for purposes other than the ones it
is designed for may result in damage or destruction of the processing unit and/or its accessories or
connected components.
The device has a built in anti-tampering module which will destroy the unit if it is improperly opened.
There are no end user serviceable parts on the inside of the unit.
1.2.3 Surrounding Area
When moving this unit from a cold place to a warmer place, watch out for condensation. Do not
immediately operate the unit until any possible condensation has evaporated. The unit is not weather
proof and water, moisture or condensation can destroy the unit.
Avoid strong magnetic fields, which may occur in places where there are large electric motors or
unshielded loudspeakers. Try to avoid using this equipment if someone else is using this type of
equipment closely.
Avoid using this equipment around active military installations and airports or where there may be other
devices that may hamper the signals received. Radars for aircraft, boats and weather reporting may
lower the units capabilities.
OKM GmbH
www.okmmetaldetectors.com