Olimpia splendid Maestro Smart - Air Duct and Grille Assembly; Prepare Unit Holes; Fitting Unit on Bracket

MAESTRO SMART
US-ENG- 9
US-ENGLISH
2.4.3 - ASSEMBLY OF THE AIR DUCTS AND EXTERNAL GRILLES (g.10-11-12)
• Afterhavingdrilledtheholes,inserttheplasticsleeves(suppliedwiththeunit)intothem.Sincethe
sleeves are made for 8” (200 mm) holes, the installer will have to trim 5.1” (129 mm) from the long side
of the sleeve, if using 6.4” (160 mm) holes.
The length of the sleeves must be 2.5” (63.5 mm) less than the thickness of the wall. Roll up the sleeves
and insert them into the hole. Pay attention to the splicing line (G) which must always face upwards.
To position the external grids, proceed as follows:
a. Applytheseal(D)tothewallange(F),ensuringitlinesupwiththeouteredgeoftheangeasindicated
inthegure13.
b. Fixthetwoangesusing2pegswithadiameterof1/4”(6mm)andcheckthatthetwoxingholesare
horizontal.
c. Fitthesmalleyeletofthespring,withthelongstem,onthecappin,onbothcomponents.(g.17)
d. Insert the two caps (with spring), on the front part of the external grille, on its two housings, pulling until
itclicks(g.18)thencouplethetwochainstothelargeeyeletofthespring.
e. Using one hand, grip the two chains connected to the grille.
f. Bendtheexternalgrilleback,grippingthemwithyourfreehandwheretheybendandinsertyourngers
insidethesinglelouvres(g.19).
g. Insert your arm into the sleeve until the grille protrudes completely outwards. reopen the grille, being
carefultokeepyourngersinsidethelouvres.
h. Turn the grille until the louvres are fully horizontal and tilted downwards.
i. Pullthechain,tensioningthespring,couplethechainringtothepinoftheinnerangethroughwhich
thesleevespass(g.20).
l. Use hand shears to cut off any excess chain links.
Olimpia Splendid recommends using the supplied grilles, or grilles with similar char-
acteristics that are factory approved to ensure proper unit performance.
2.4.4 - PREPARING THE HOLES ON THE UNIT
The unit is designed to operate with 6.4” (165 mm) sleeves, however to ensure the best performance and
lowest air noise level, the factory recommendation is to use the 8” (200 mm) holes. if using the 8” (200 mm)
sleevesuseacuttertoremovetheknockoutfromtherearoftheunit(g.21).
2.4.5 - FITTING THE UNIT ON THE BRACKET (g.22-23-24-25)
After ensuring the mounting bracket is properly anchored to the wall and that all required preparatory work
hasbeencarriedoutfortheelectricalconnectionsand/orthecondensatedrainagetheunitcanbexedto
the wall. Lift the unit by holding it from the sides of the lower base.
To facilitate the operation of fastening it to the bracket, tilt it slightly toward you. To make the electrical con-
nection and fasten the drain pipe, place a wedge between the unit and the wall.
 Whenyouhavenished,inspectcarefullytomakesuretherearenoopenspacesattherearoftheunit.
 Theinsulatinggasketmusttrmlyagainstthewall,particularlyintheareawhereairentersandleavesthe
unit.