31Service Guide
Replacing Parts
8 Before you leave the customer site, verify the Fiery ES operation.
• Connect the Fiery ES to the network (see page 19).
• Ask the site administrator to check the Setup options (see Configuration and Setup).
• Power on the Fiery ES, and then the printer. Wait for the Fiery ES LED display to reach and remain at 00; then wait
for the Fiery icon to become active (see page 12).
• In the event of an error condition, see the Startup section of the table on page 46. If the Fiery icon does not become
active after 10 minutes, check and reseat all external cables; make sure that the cables are connected to the correct
ports. If image quality is poor, test the printer (see the service documentation that accompanies the printer).
To Next Page
Loading...