Olivetti IC-420 - Restoring the System Configuration

34Service Guide: Fiery® ES IC-420
Installing System Software
5 Log on with Administrator privileges and click OK.
The default Administrator password is Fiery.1 (case-sensitive), but the site administrator may have changed the
password.
6 Select Fiery Server > Backup.
7 Select the settings you want to back up and specify the backup filename, then click Backup.
The backup process starts. Wait until the “Backup Completed!” message appears.
The backup reference file and data file will be created. Click each download button to save the files.
8 Click OK.
Restoring the system configuration
You can restore the configuration of the Fiery ES to an earlier state using a configuration file. For more information about
creating a configuration file, see “Backing up and restoring the system configuration” on page 33.
Note: If you were unable to create a configuration file, you must configure Setup. After you exit Setup and the Fiery ES
reboots, ask the site administrator to restore any archived settings and files that were saved. For more information, see
Configuration and Setup, which is part of the user documentation set.
To restore the system configuration
1 Connect your computer to the same network as the Fiery ES, and open a Web browser window.
Note: Request the permission from the network administrator before you connect your computer to the network.
2 In the URL field of the browser, type the IP address or server name of the Fiery ES, and press Enter to open the
WebTools page.
The IP address and server name are listed on the Configuration page.
3 In WebTools, click Configure tab > Launch Configure.
4 Log on with Administrator privileges.
The default Administrator password is Fiery.1 (case-sensitive), but the site administrator may have changed the
password.
5 Select Fiery Server > Restore.
6 Select the reference file and the data file that you saved earlier, and click Next.
7 Select the settings to restore, and then click Restore.
The restore process starts. Wait until the “Restore Completed!” message appears.
8 Click Reboot.
Service Guide
Y119660-9