olympia electronics GR-6500 - Menu Settings

24/02/2020 20 / 24 923650001_09_008.doc
• “SYSTEM” where you can automatically setup (register) all points of the loop
• “POINTS” configure each point of the panel
• “SETTINGS” configure parameters of the panel. See paragraph 4.1.
• “ENABLE” a point, a zone, all zones.
• “DISABLE” a point, a zone, all zones.
• “EVENTS” to clear event log.
• “CODES” to change the technician code.
• “MODE INHIBIT” set permission to the panel of using the inhibit mode.
• “SET FUNCTION TEST” configures when the function test takes place. See paragraph 4.2
• “SET CAPACITY TEST” configures when the capacity test takes place. See paragraph 4.3
• “MAKE A CAPACITY TEST” makes or stops a capacity test.
• “RESET DEFAULTS” loads the factory settings.
• “ANNUAL CHECK DONE” the annual check from the technician was made.
• “ETHERNET” configure Ethernet module. See paragraph 4.4.
4.1. Menu Settings
The menu settings has the options bellow:
SETTINGS
DAY OF WEEK SETTING
DATE SETTING
TIME SETTING
SELECT LANGUAGE
MENU MANUFACTURER
BUZZER SETTINGS
ANNUAL CHECK WARNING
Figure 4-15
• “DAY OF WEEK SETTING” set the day of the week
• “DATE SETTING” set the date of the panel