olympia electronics GR-6500 - Ethernet Menu

24/02/2020 22 / 24 923650001_09_008.doc
MAKE CAPACITY TEST ALL ZONES
ONE ZONE ONLY
MAKE A CAPACITY TEST
STOP CAPACITY TEST ALL ZONES
ONE ZONE ONLY
Figure 4-18
It is also possible to stop a capacity test from the same menu (see figure above).
4.4. Ethernet menu
At the Ethernet menu you can set the Ethernet parameters
ETHERNET ETHERNET PCB
IP ADDRESS
RESET ETHERNET
Figure 4-19
• “ETHERNET PCB” check if the pcb is present or not
• “IP ADDRESS” set the IP address of the panel
• “RESET ETHERNET” reset the Ethernet module