57
2
Shooting and playback basics
Protecting pictures
You are recommended to protect important pictures to avoid accidentally
erasing them. Protected pictures cannot be erased by the single-frame/all-
frame erase function.
1
Set the mode dial to and
turn the camera on.
“Power on/off” (P.31)
• The monitor turns on.
2
Use the arrow pad or jog dial to
display the picture you want to
protect.
“Viewing still pictures” (P.53)
3
Press .
• To cancel protection, press again.
• Protected pictures cannot be erased by the single-frame/all-frame
erase function, but they are all erased by formatting.
• Protection cannot be applied to pictures stored on a card
(SmartMedia) with a write-protect seal attached.
Mode dial
Protect button
Power switch
Jog dial
Arrow pad
Mode dial
Displayed when a picture is
protected.
Note
To Next Page
Loading...
