58
2
Shooting and playback basics
Erasing pictures (Single-frame erase)
This function erases only the picture displayed on the monitor. The all-frame
erase function can be used to erase all the pictures on the card at once.
“All-frame erase” (P.163)
• You cannot erase pictures that are protected or stored on a write-
protected SmartMedia card. Cancel protection or remove the write-
protect seal before erasing such pictures.
• Once erased, pictures cannot be restored. Check each picture
before erasing to avoid accidentally erasing pictures you want to
keep. “Protecting pictures” (P.57)
• Pictures protected (read only) by the PC are also erased. To prevent
erasure, the pictures have to be protected on the camera.
“Protecting pictures” (P.57)
1
Set the mode dial to and
turn the camera on.
“Power on/off” (P.31)
• The monitor turns on.
2
Use the arrow pad or jog dial to
display the picture you want to
erase.
“Viewing still pictures” (P.53)
3
Press .
• The ERASE screen is displayed.
4
Press to select YES, then
press .
• The picture is erased and the menu is
closed.
Note
Mode dial
Mode dial
Power switch
Jog dial
Arrow pad
Erase button
YES
NO
SELECt
GO
ERASE
To Next Page
Loading...
