85
5
Flash
Flash intensity control
You can adjust the amount of light emitted by the flash.
In some situations, you may get better results by adjusting the light emission.
Examples include small subjects, distant backgrounds, or situations when
increased contrast is desired. You can adjust the brightness in the range of
±2.0 in 1/3 EV steps.
1
Adjust the brightness by turning
the jog dial while holding down
and at the same time.
• The exposure value is displayed on the
control panel while the flash intensity
control function is set.
• The flash adjustment effect may not be sufficient if the shutter speed
is too fast.
Mode dial
Exposure compensation
button
Flash mode
button
Jog dial
Turning to the left
decreases light emission in
steps of 1/3 EV.
Turning to the right
increases light emission in
steps of 1/3 EV.
(EV : Exposure Value)
Note
To Next Page
Loading...
