Olympus CLV-180 - Page 59

Disassembly and Reassembly ProcedureCLV-180
4-22
ISSUE1
(8) Take off 2 SCREWS (CCUK3x4SZ) and M LIMIT
SWITCH
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(9) Take off 4 SCREWS (CCUK3x4SZ) and M TURRET
U
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(10) Take off 4 SCREWS (CCUK3x4SZ) and 180 MESH
BK BASE
Phillips bit(№2)
Torque driver
Tightening torque 0.6 Nm
(11) Take off 4 SCREWS (CCUK4x12SZ) and S SOCKET
180U
 *Fix the S SOCKET 180U by pushing
counterclockwise for Reassembly in order to align
the optical axis .
→ go to 3-4-3
Phillips bit (№2)
Torque driver
Tightening torque 1.4 Nm
CCUK3x4SZ
180 MESH
BK BASE
CCUK4x12SZ