Disassembly and Reassembly ProcedureCLV-180
4-23
ISSUE1
(12) Take off DIAPHRAGM HARNESS from
DIAPHRAGM U
(13) Take off 2 SCREWS (CCUK3x6SZ) and
DIAPHRAGM U
Phillips bit (№2)
Torque driver
Tightening torque 1.4 Nm
DIAPHRAGM POSITIONING JIG(for reassembly)
*Push the side that has no slit on JIG towards the rear
and make the DIAPHGRAM stay inside the slit as seen
from above.
(14) Take off EMERGENCY HARNESS from MINI
CRAMP
(15) Take off 4 SCREWS (CCUK3x4SZ) 、 LENS
RETAINER 2 and LENS RETAINER 3
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(16) Take off 1-T and 2-T from LENS BASE
(17) Take off 2 SCREWS (CUKSK3x6SZ) and LENS
RETAINER U
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(18) Take off 3-T and 4-T from LENS BASE
(19)Take off 1 SCREW (CCUK3x4SZ) and LIMIT SW U
Phillips bit (№2)
Torque driver
Tightening toque 0.6 Nm
DIAPHGRAM
HARNESS
(15)CCUK3x4SZ
LENS
RETAINER 3
LENS
RETAINER 2
1-T
2-T
CUKSK3x6SZ
3-T
4-T
LENS RETAINER U
To Next Page
Loading...
