Disassembly and Reassembly ProcedureCLV-180
4-24
ISSUE1
(20)Take off 3 SCREWS (CCUK3x8SZ) and TURRET
180U
→Go to 3-4-4
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
3-4-1 Front panel U
(1) Take off 6 SCREWS (T2CCUK3x8SZ) and 180 FP
CHASSIS
Phillips bit (№2)
Torque driver
Tightening torque 0.3 Nm
(2) Take off 2 SCREWS (CCUK3x4SZ) and CORE
HOLDER 180
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(3) Cut BINDER and take off CORE
Nipper
(4) Take off BINDER
(5) Take off 9 SCREWS(CCUK3X4SZ), 180
SHIELDING PLATE and FP SHEET
* In case of trading FP CHASSIS, take off GASKET
F260
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
CCUK3x8SZ
(2) CCUK3x4SZ
180
SHIELDING
PLATE
GASKET F260
FP
SHEET
180 FP CHASSIS
CORE HOLDER
180
To Next Page
Loading...
