105
8
Notes on Recording For Voice Recognition
When recording voice to be processed
with voice recognition, set up your
DSS recorder as follows to improve
recognition accuracy.
• Set the microphone sensitivity to
“DICTATION” (☞ P.25).
• Set the recording mode other than “LP”
mode (☞ P.22).
• Set the Variable Control Voice Actuator
(VCVA) to “OFF” (☞ P.23).
• Register/enroll your voice in the voice
recognition software using the recorder.
• Record in a relatively quiet environment.
• Have the recorder microphone 5 to 10
cm away from your chin.
The file recorded in the next condition,
will be a low rate of recognition, which
can not be used for voice recognition.
• A conference or meeting where many
voices are recorded.
• Seminar or lecture where high-level
ambient noise tends to be recorded.
• Speak normally.
• When your voice is to be recorded, and
reduce the influence of the surrounding
noise, set the recording mode to “HQ”
or “SP”, and use the ME12 microphone
for dictation recording.
Using Voice Recognition Software
To Next Page
Loading...
Need help?
General
