110
EN
Customizing your camera
9
USB MODE
You can connect the camera directly to a computer or printer with the provided USB cable. If
you specify the device you are connecting to beforehand, you can skip the USB connection
setting procedure normally required every time you connect the cable to the camera. For
details on how to connect the camera to either device, refer to “Connecting the camera to a
printer” (gP. 124) and “Using the OLYMPUS Viewer 2 / [ib]” (gP. 127).
[AUTO]
The selection screen for the USB connection will be displayed every time you connect
the cable to a computer or printer.
[STORAGE]
Allows you to transfer images to a computer. Also, select to use the OLYMPUS
Viewer 2 / [ib] software via PC connection.
[MTP]
Allows you to transfer images to a computer running Windows Vista without using the
OLYMPUS Viewer 2 / [ib] software.
[PRINT]
Can be set when connecting the camera to a PictBridge-compatible printer.
[CONTROL]
Allows you to control the camera via the USB connection by using the Olympus
Studio 2.
LEVEL GAUGE
This camera has an acceleration sensor that enables display of a bi-directional level gauge to
detect tilting horizontally and in the forward and backward direction when [LEVEL G
AUGE] is
set to
[ON]. Use this as a guide in situations where you cannot determine whether the
camera is level, such as when you cannot see the horizon or skyline on the screen or when
the screen is dark while shooting night scenes.
Viewfinder and control panel indications:
Press the shutter button halfway to display the level gauge in the viewfinder and on the
control panel after a few seconds.
Monitor indication:
Press the INFO button repeatedly to display the level
gauge. g“Switching the information display” (P. 39)
Viewfinder Control panel
Horizontal level indicator
Displayed when outside the display
range.
s0033_e_00_0_unified.book 110 ページ ２０１０年１１月１６日 火曜日 午後５時２４分
To Next Page
Loading...
