Olympus EVIS EXERA III - SET UP - 190 SERIES LIGHT SOURCE AND PROCESSOR WITH 180 SERIES ENDOSCOPES

SET UP - 190 SERIES LIGHT SOURCE AND
PROCESSOR WITH 180 SERIES
ENDOSCOPES
1. Ensure plug end (electrical connector) of endoscope (on the light guide connector of the
endoscope) is dry before plugging into light source. Connect suction air/water valves
and biopsy cap to endoscope.
2. Connect video Link (curly) cable to video processor, inserting the cable with the “ridge”
facing upwards and the word “UP” visible. Insert the connector until a “click” sound is
heard.