135
Chapter 6 Measurement procedures
2 Select “NEW STEREO ADAPTER” in the stereo optical adapter list
and then press the [MEAS/ENTER] joystick.
3 Insert an optical data media (CF card or USB memory) into the
RECORDING CARD slot or the USB connector.
If a recording card is inserted, the message shown below is displayed. Remove
the recording card and insert an optical data media.
Select “OK” and then press the [MEAS/ENTER] joystick. The new stereo optical
adapter’s name and set number are displayed.
4 Make sure that the adapter name and the set number for the new
stereo optical adapter are correct and then select “OK” and press
the [MEAS/ENTER] joystick.
To Next Page
Loading...
