139
Chapter 6 Measurement procedures
9 The environment data for the new stereo optical adapter is stored in
the base unit’s internal memory when the white image has been
captured successfully. Then the “NEW STEREO ADAPTER” is
completed.
The following message is displayed. Remove the optical data media (CF card or
USB memory) from the RECORDING CARD slot or the USB connector and then
select “OK” and press the [MEAS/ENTER] joystick.
10 Keep the optical data media in the optical adapter case so it does
not get lost.
NOTE
• After a new stereo setup is completed, a file with the name “IV7CALIB\FREEZE.TIF” is
created on the optical data media. Removing this file does not affect operation.
To Next Page
Loading...
