73
Chapter 4 Basic operations
Withdrawing the scope
Remove your finger from the [ANGLE] joystick and carefully observe as you
withdraw the scope.
Troubleshooting when the hook is caught (IV8635X1
only)
Protrude the hook assembly from the scope’s distal end and turn the hook
assembly to unhitch the hook. If withdrawal is still impossible jettison the hook
from the spring shaft according to the following procedure.
1 Firmly tighten the chuck screw of the channel port to securely fix
the hook assembly.
2 Pull the control unit slowly and forcefully so that the insertion tube
and bending section are straight. The hook will fall off the spring
shaft.
Inspection part
To Next Page
Loading...
