Why does my Olympus IPLEX NX IV9435N Industrial Equipment optical adapter not attach to the insertion tube?
The inability to attach the optical adapter could be due to a foreign object stuck to the screws. Try wiping with a clean piece of gauze or a cotton swab. It could also be that you are not using the designated optical adapter for this system, so ensure you are using the correct adapter. Finally, the installation procedure may be incorrect.
What to do if Olympus IPLEX NX IV9435N Industrial Equipment displays
This message indicates that the resolution of the live image differs from that of the played-back image. Specify a file with the same resolution as the live image.
Why is the image brightness not optimal on my Olympus IPLEX NX IV9435N?
Suboptimal image brightness can occur if the objective lens of the distal end of the insertion tube or the optical adapter is dirty, or if the illumination on the optical adapter is dirty. Wipe these with a clean piece of gauze or a cotton swab. Also, check the automatic brightness control setting using the [BRT] button and ensure the external monitor is properly adjusted. Finally, make sure the optical adapter is correctly attached.
What to do if Olympus IPLEX NX IV9435N displays
This message indicates that the SDHC card is locked. Unlock the SDHC card you intend to use and then insert it into the instrument.
What to do if Olympus IPLEX NX IV9435N shows
If you see this message, it could be due to using a USB flash drive not recommended for the equipment or connecting a USB device other than a USB flash drive. Stop the inspection, turn the instrument off and then on again, and use the recommended USB flash drive. Also, disconnect any USB devices that are not the USB flash drive.
What to do if Olympus IPLEX NX IV9435N displays
If you see this message, it means the file name you are trying to use already exists. Specify a file name that is different from the existing one.
What to do if Olympus IPLEX NX IV9435N displays
This message indicates that the self-check function was activated due to an overcurrent in the light source. Terminate the inspection, allow the instrument to cool down, and then turn the power back on again.
How to fix Olympus IPLEX NX IV9435N Industrial Equipment if illumination does not light?
If the illumination does not light, ensure that the [LIGHT] button is turned ON.
What to do if Olympus Industrial Equipment displays
This message indicates that the distal end has become too hot, activating the self-check function. Immediately pull the insertion tube out of the observation object.
What to do if Olympus Industrial Equipment displays
This message means that the format of the SDHC card or USB flash drive is not recognized. You should format the SDHC card or USB flash drive using this instrument.
General| Model | IPLEX NX IV9435N |
|---|---|
| Category | Industrial Videoscope |
| Resolution | 640 x 480 pixels |
| Light Source | LED |
| Working Length | 3.5 m |
| Field of View | 90° |
| Weight | 2.9 kg |
| Storage Temperature | -20 °C to 60 °C |
| IP Rating | IP55 |
| Image Sensor | CMOS |
| Insertion Tube Diameter | 4.0 mm |
| Direction of View | Forward |
Essential precautions for safe handling and use of the instrument.
Specific safety measures for handling and attaching the hook assembly.
Precautions for safe use, charging, and disposal of the instrument's battery.
Instructions for loading the battery and connecting the AC adapter.
Checklists for ensuring instrument integrity before and after use.
Steps to turn the instrument on and adjust illumination levels.
Guidance on using controls, observing objects, and withdrawing components.
Procedures for capturing, saving, and reviewing images and movies.
Verifying measurement accuracy before and after the procedure.
Detailed guide on performing measurements and recording results.
Detailed guide on setting reference points, length, and recording results.
Guidance on identifying and resolving instrument issues and error indicators.
Addressing frequently encountered issues and their recommended fixes.
To Next Page
