How to fix poor color reproduction on Olympus IPLEX NX IV9435N?
Poor color reproduction can be due to an improperly set white balance or incorrect image color settings. Try adjusting the white balance and the image color.
What to do if Olympus IPLEX NX IV9435N Industrial Equipment displays
This message indicates that the insertion tube is overloaded and the self-check function was activated. Extend the insertion tube as much as possible to reduce the loop amount, and then turn the power back on without operating the [ANGLE/LOCK] joystick.
What to do if Olympus IPLEX NX IV9435N Industrial Equipment displays
This message indicates that the SDHC card or the USB flash drive is not loaded. Load the SDHC card or the USB flash drive you intend to use and try again. Alternatively, turn the instrument off and then on again.
Why is my Olympus IPLEX NX IV9435N not turning on?
Several reasons may prevent the system from turning on. Make sure the AC adapter or battery is correctly connected. Ensure the power is switched ON. Verify that you are using the designated AC adapter or battery. Finally, check that the scope unit is properly attached to the main unit.
What to do if Olympus IPLEX NX IV9435N displays
This message indicates that the battery voltage is low. Stop all operations like recording, copying, deleting, or formatting the USB flash drive. Replace the battery immediately or connect the AC adapter.
Why is my Olympus IPLEX NX IV9435N image not sharp?
The lack of sharpness may be due to a dirty objective lens on the distal end of the insertion tube or the optical adapter. Try wiping it with a clean piece of gauze or a cotton swab. Also, ensure the optical adapter is correctly attached and that both the image sharpness and external monitor are properly adjusted.
What should I do if my Olympus IPLEX NX IV9435N displays
If your device shows this message, it means the SDHC card or USB flash drive is full. You should delete any unnecessary data to create more space, or replace it with a new SDHC card or USB flash drive.
General| Model | IPLEX NX IV9435N |
|---|---|
| Category | Industrial Videoscope |
| Resolution | 640 x 480 pixels |
| Light Source | LED |
| Working Length | 3.5 m |
| Field of View | 90° |
| Weight | 2.9 kg |
| Storage Temperature | -20 °C to 60 °C |
| IP Rating | IP55 |
| Image Sensor | CMOS |
| Insertion Tube Diameter | 4.0 mm |
| Direction of View | Forward |
Essential precautions for safe handling and use of the instrument.
Specific safety measures for handling and attaching the hook assembly.
Precautions for safe use, charging, and disposal of the instrument's battery.
Instructions for loading the battery and connecting the AC adapter.
Checklists for ensuring instrument integrity before and after use.
Steps to turn the instrument on and adjust illumination levels.
Guidance on using controls, observing objects, and withdrawing components.
Procedures for capturing, saving, and reviewing images and movies.
Verifying measurement accuracy before and after the procedure.
Detailed guide on performing measurements and recording results.
Detailed guide on setting reference points, length, and recording results.
Guidance on identifying and resolving instrument issues and error indicators.
Addressing frequently encountered issues and their recommended fixes.
To Next Page
