Before commencing shelf adjustment, ensure equipment is
disconnected and removed from the shelf.
Use the following steps to reposition the intermediate shelves.
1. Remove any equipment that is on the shelf.
2. Position the workstation on a flat surface and apply the brakes on two diagonally opposite
castors.
3. Remove the two cable ducts that are fitted on the rear of the intermediate shelf and the cable
tie that is fitted at the same height as the shelf. You can remove the cable tie by inserting a
flat bladed screwdriver behind the stud in the middle of the cable tie and pulling it towards
you, as shown in Figure 4.5.
4. Check that nothing has been placed on the shelf and, referring to Figure 4.6, loosen the two
M8 screws that are securing the shelf about half a turn using the supplied 6mm Allen key –
do not remove.
Figure 4.5
To Next Page
Loading...
