O.M.A.C. s.r.l.
Via Giovanni Falcone, 8 42048 Rubiera (RE) - Italy Tel.0522/629371 - 629923 Fax 0522/628980
Rev.4 del 01/2011 O.M.A.C. s.r.l.
The center of mass position is indicative and it depends by LDPU confi guration.
WARNING
IT IS ABSOLUTELY FORBIDDEN TO HOIST THE LDPU WITH METHODS OTHER THAN THOSE INDICATED.
NO!
= center of mass
• ensure that the belts do not strain and that their position around
the LDPU does not move when hoisting; in the event there is a speed
controller fi tted, make sure that the belts do not strain on the control hand-
wheel;
• hoist the LDPU from the ground by about 20 - 25 cm and move
it to installation place.
The position of the centre of mass is indicative because it depends on the
confi guration of the LDPU.
To Next Page
Loading...
