OMC RE20 - Travel Zero (TVL ZERO) and Travel End (TVL End)

35
Installation
,
O
p
eration and Maintenance Manual ManRE20en Rev.06/2022
OMC S.p.A: Via G. Galilei, 18 - 20060 - Cassina de Pecchi (MI) - ITALY - www.omcvalves.com - Tel.: (+39) 02.95.28.468
8.6.4 Travel Zero (TVL ZERO) and Travel end (TVL ENd)
This is a manual adjustment of the zero point or endpoint of the valve after auto calibration. Once you
enter the TRAVEL ZERO (or TRAVE END) setting, press the UP/DOWN button to change the zero
point (or endpoint) of the valve, and then press the ENTER button to save it. The saved position is
recognized as the zero (or endpoint) of the valve.
  
Press <UP> or
<DOWN> button
if the above is not
displayed.
Zero Adjustment
<UP>/<DOWN>

<ESC>

<DOWN>


<UP>/<DOWN>

<ESC>

End Adjustment
<ESC>
2 times
