OMC RE20 - Device Configuration (Dev CFG); Action Setting (ACT)

52
Installation
,
O
p
eration and Maintenance Manual ManRE20en Rev.06/2022
OMC S.p.A: Via G. Galilei, 18 - 20060 - Cassina de Pecchi (MI) - ITALY - www.omcvalves.com - Tel.: (+39) 02.95.28.468
8.11 Device Configuration (dEV CFG)
Followings are the values changeable at the dEV CFG Mode.
1) Action Setting (ACT REVS / dIR)
2) Linear Interpolation (ITP oFF / on)
3) Lock of Parameters (Write Protect, W UNLOCK / LOCK)
4) Actual Position View Mode (View Mode, VI NORM / REVS)
5) Factory Reset (dEFAULT oFF / on)
6) Positioner Self-Test (SELFTEST)
8.11.1 Action Setting (ACT)
Reverse Action (REVS) or Direct Action (dIR) are automatically set by performing “AUTO 2” within
the Auto Calibration function. However, this function is used when the user requires to change ACT
REVS or ACT dIR to other action. Changing the action from Reverse Action (REVS) to Direct Action
(dIR) or Direct Action (dIR) to Reverse Action (REVS) will also change the Signal Direction (SIG),
Position Transmitter Direction (PTM), HART Feedback Direction (HT) and View Mode (VI).
3 seconds

 
Press <UP> or
<DOWN> button
if the above is not
displayed.
Press <UP> or
<DOWN> button
if the above is not
displayed.
<UP>/<DOWN>

<ESC>
3 times
