OMC RE20 - Actual Position View Mode (View Mode, VI NORM; REVS); Factory Reset (Default off; On)

54
Installation
,
O
p
eration and Maintenance Manual ManRE20en Rev.06/2022
OMC S.p.A: Via G. Galilei, 18 - 20060 - Cassina de Pecchi (MI) - ITALY - www.omcvalves.com - Tel.: (+39) 02.95.28.468
8.11.4 Actual Position View Mode (View Mode, VI NORM / REVS)
This function is used to set the "RUN AP" value on the LCD to be displayed as direct (NORM) or
reversely (REVS) as the actual position of the valve.
3 seconds

 
Press <UP> or
<DOWN> button
if the above is not
displayed.
Press <UP> or
<DOWN> button
if the above is not
displayed.
<UP>/<DOWN>

<ESC>
3 times

8.11.5 Factory Reset (dEFAULT oFF / on)
This function initializes all parameters stored in the positioner to initial factory setting. In the dEFAULT
mode, pressing the Enter button for approximately 3 seconds enables ON/OFF setting mode and
then setting it to ON resets all parameters.
Pay attention when using this mode as all the parameter values will be changed to the factory
settings.
3 seconds


3 seconds

Press <UP> or
<DOWN> button
if the above is not
displayed.
Press <UP> or
<DOWN> button
if the above is not
displayed.
3 seconds


automatically

<ESC>
3 times
