9
Meter Function Menus
9-4
MENU MIN/MAX*
BUTTON BUTTON
MAIN MENU SUB MENU CONDITION
“L2 CNF”
“L2C.7=0” CNT BY (round off of display) can be
specified.
“L2C.7=1” CNT BY (round off of display) cannot be
specified.
“L2C.8=0” FIL CNF (adaptive/fixed filtering and for
which output(s)) can be chosen.
“L2C.8=1” FIL CNF (adaptive/fixed filtering and for
which output(s)) cannot be chosen.
* The ‘MIN’ button allows you to sequence through L2C.1, L2C.2, L2C.3,
L2C.4, L2C.5, L2C.6, L2C.7, and L2C.8.
The ‘MAX’ button allows you to select the “0” or “1” state for each “L2C”
condition.
The ‘MENU’ button stores the selected values for all “L2C” condition(s)
changed and advances the meter to “L3 CNF”. Do not press the ‘MENU’
button after each change within the submenu or the meter will advance to
the next menu item.
Every underlined “0” or “1” state is the factory preset value.
MENU MIN/MAX*
BUTTON BUTTON
MAIN MENU SUB MENU CONDITION
“L3 CNF”: LOCKOUT CONFIGURATION#3
“L3C.1=0
” FIL TI (# of samples in average) can be
chosen.
“L3C.1=1” FIL TI (# of samples in average) cannot be
locked out.
“L3C.2=0” SP CNF (mode of action of setpoints 1 & 2
LEDs, transistors and relays) can be
selected.
“L3C.2=1” SP CNF (mode of action of setpoints 1 & 2
LEDs, transistors and relays) cannot be
locked out.
“L3C.3=0
” AL CNF (mode of action of Setpoints 3 & 4,
often used as alarms) can be locked out.
To Next Page
Loading...
