8-11
8
Scaling to
Display
Engineering
Units
STRAIN
0
Pressing the ‘RESET’ button one time brings you back one menu
item, pressing the ‘RESET’ button two times returns you to the run
mode.
WARNING! this also results in a hard reset of your peak and valley
and setpoints.
Proceed through the flow chart below entering the values listed in
submenu 1 and 2 columns.
MENU SUBMENU 1 SUBMENU 2 DESCRIPTION
L1CNF Skip past
L2CNF Skip past
L3CNF Skip past
L4CNF Skip past
INPUT BRIDGE Meter’s input.
RDG.CNF RDG.1=0 2-point scaling IN.SC.OF
RDG.2=0 Active decimal point
RDG.3=0 Normal display brightness
RDG.4=1 Leading zeros suppressed
RDG.5= Disregard not used
RDG.6= Disregard not used
RDG.7=0 External hard reset vs
only peak reset
RDG SC 1.00000 Preset for IN.SC.OF
RDG OF 0000000 Preset for IN.SC.OF
continued next page
To Next Page
Loading...
