MOUNTING COMPONENTS
The Control Module:
This contains electronic components so always mount
this module at a secure location inside the vehicle like under the dash. Ensure
that the module
is
not succeptable to moisture, excessive vibration, or exces-
sive temperatures (like next to heater hoses).
The Status Light: This may be custom mounted or placed within the included
combination holder with the valet switch.
To
custom mount, select a suitable
surface panel
in
the vehicle with high visibility from all windows and away from
moving part
of
the vehicle. Drill a 9/32" hole
in
the chosen panel, route the
light's harness through the hole and snap the light into place. Then, plug the
status light's 2 pin plug into the corresponding port on the control module.
The Valet Switch: This may be custom mounter or placed within the included
combination holder with the status light.
To
custom mount, select a suitable
surface panel
in
the vehicle that
is
easily accessed by the driver and, idealy,
not
in
plain sight. Clean the surface well and adhere the switch to the surface
using its adhesive pad. A 1/4" hole can
be
drilled to route/hide the wire harness
if
desired. Route the harness to the control module and plug it into the corre-
sponding port.
II
To Next Page
Loading...
