Omega REC-12 User Manual

Using The Valet I Override Switch ':\~"
The Valet/Override Switch can be used to place the system into Valet
Mode, which is used to stop or interrupt any automatic system functions which
may be programmed to operate. The Valet/Override Switch,
in conjunction
with your ignition
key, also permits System Override, which allows starting the
vehicle if the optional starter interrupt is installed, and the transmitter becomes
lost or damaged.
Valet Mode:
You may activate the Valet Mode at any time by press-
ing and holding the Valet/Override Switch for 3 seconds, unless the doors have
been locked by the transmitter (in which case the Status Indicator will be flash-
ing slowly). When the system enters Valet Mode, the Status Light will illuminate
solid steady Red. If the REC-12
is installed with audible confirmation, the sys-
tem will chirp twice when it enters Valet Mode. Remember to check the Status
Light - if it is not lighted or flashing fast, the system may be placed into Valet
Mode. If the Status Light is
on steady, the system is already in Valet Mode. If
it's flashing slowly, a System Override must first be performed (see next page).
While the system is
in the Valet Mode, the Status Light will remain solid
Red (not flashing) at all times. If the audible confirmation is connected, every
time the ignition switch is turned "off", the system will chirp once as a reminder
of this condition. Also, the transmitter will operate normally while the system
•

Omega REC-12 Specifications

General

Brand	Omega
Model	REC-12
Category	Remote Starter
Language	English