5
Using This Manual
Using This Manual
This User Manual provides detailed information on how to use the CP SB1
transformer switch box safely, properly and efficiently. The CP SB1 User Manual
contains important safety instructions for working with the CP SB1, gets you
familiar with operating the CP SB1, and provides typical application examples.
Following the instructions in this User Manual will help you to prevent danger,
repair costs and possible down time due to incorrect operation.
The CP SB1 User Manual always has to be available at the site where the
CP SB1 is used. It must be read and observed by all users of the CP SB1.
Reading the CP SB1 User Manual alone does not release you from the duty of
complying with all national and international safety regulations relevant to
working with the CPC 100 and CP SB1. The regulation EN 50191 "The Erection
and Operation of Electrical Test Equipment" as well as all the applicable
regulations for accident prevention in the country and at the site of operation has
to be fulfilled.
Operator Qualifications and Safety Standards
Working on overhead lines is extremely dangerous. Testing and measuring with
the CP SB1 must be carried out only by qualified, skilled and authorized
personnel. Before starting to work, clearly establish the responsibilities.
Personnel receiving training, instructions, directions, or education on the
CP SB1 must be under constant supervision of an experienced operator while
working with the equipment.
Testing and measuring with the CP SB1 must comply with the relevant national
and international safety standards listed below:
• EN 50191 (VDE 0104) "Erection and Operation of Electrical Equipment"
• EN 50110-1 (VDE 0105 Part 100) "Operation of Electrical Installations"
• IEEE 510 "IEEE Recommended Practices for Safety in High-Voltage and
High-Power Testing"
Moreover, additional relevant laws and internal safety standards have to be
followed.
To Next Page
Loading...
General