Safety precautions
vi
Caution
(for installation and connection)
Do not connect devices such as dryers, some solenoid valves, etc., which
have a half-wave rectifier that allows only half-cycle AC power to flow
through.
●
Overcurrent may damage the UPS.
Connect the unit to a wall outlet (commercial power) with the appropriate
capacity (12A or greater for BN75R, 20A or greater for BN150R and 40A or
greater for BN300R.).
●
Otherwise, the power cord may be heated.
●
When equipment with the maximum output capacity is connected, a maximum current of 12A
(BN75R) or 20A (BN150R) or 40A (BN300R).
When changing the input cable for the BN150R/BN300R, perform
connection as specied.
Make sure to properly match the AC input terminal with the appropriate
wire color
.
Do not perform work on the AC input terminal while the unit is connected
to a commercial pow
er source.
●
UseaninputcablethatcomplieswiththeinputcurrentspecicationoftheUPS.
●
Failure to do so may result in electric shock or ground fault.
Provide secure grounding.
●
After checking the plug shape of the wall outlet, directly connect the AC input plug of the unit to it. A
failure or leak that occurs when the unit is not properly grounded may result in electric shock.
Do not disassemble, repair, or modify the unit.
●
Doingsomaycauseanelectricshockorare.
Do not install the unit in other than specied orientations.
●
Dropping or toppling the unit may cause injury.
●
Ifyouinstalltheunitinanorientationotherthanspecied,theunitcannot beprotectedfroma
battery
uidleakage.
●
Use the included vertical stand when positioning the unit vertically. (Only BN150R and BN300R)
Do not use the unit where the maximum temperature exceeds 40°C.
●
The battery deteriorates rapidly.
●
Doing so may cause a failure or malfunction of the unit.
Do not exceed the ranges specied for environmental conditions during
use/storage.
Do not install or store the unit in the places listed below.
●
Do not store in places where the humidity is lower than 10% or higher than 90%.
●
Do not use the unit in places where the ambient temperature is lower than 0°C or higher than
40°C. (With no condensation)
●
Do not use in places where the humidity is lower than 10% or higher than 90%.
●
Do not install/store the unit in closed places such as cabinets with no clearance, places where
there
is
ammable
or
corrosive
gas,
places
with
large
amounts
of
dust,
places
exposed
to
direct
sunlight, places exposed to shock or vibration
, salty or wet places, or outdoors.
●
Installationorstoringtheunitinsuchaplacemaycauseare.
Do not connect equipment that exceeds the output capacity of the unit.
You can use plug strip to connect additional devices, but do not connect
devices that exceed the current capacity of the plug strip.
●
The current protection of the unit may operate, which may stop the output.
●
Thewiringoftheplugstripheatsup,whichmaycauseare.
To Next Page
Loading...
Need help?
General
