Omron Colin BP-203RPE III - Replacing Cuffs; Replacing an Arm Cuff; Replacing an Ankle Cuff

126
5-2. Replacing Cuffs
The procedures for disconnecting and connecting the air hose when replacing a soiled, old, or
unusable cuff with a new cuff or changing the cuff to a different size cuff is explained below.
Replacing an Arm Cuff
1. Turn the air hose connector counterclockwise to
disconnect it from the cuff.
2. Insert the connector on the new cuff into the air
hose. Turn the connector clockwise until it clicks
into place.
Replacing an Ankle Cuff
1. Squeeze the removal levers (1) on the sensor box
and remove each cuff connector (2).
The levers are small and slippery.
Squeeze the levers firmly.
2. Insert each connector on the new cuff into the
sensor box until it clicks into place.
Caution
The sensor box removal lever uses a strong spring mechanism. Hold the sensor box
firmly and press down hard on the lever from the exterior to remove the connector. This
may cause injury with the metal edges.
Right
Left
Left
Right
BP-203RPE3(A).fm 126 ページ 󲥿󲥽󲥽９年󲥾󲥿月󲥿６日 土曜日 午後５時４󲥿分