19
1-7. Installation/Moving
Inspection Before Starting Work
For safe and proper use, inspect the device at the start of each day. When installing the device, be
sure to follow the instructions on pages 7 to 12.
Before turning the power on
Main Unit
• Is the sensor that directly touches the patient clean?
• Are the cords arranged properly?
• Is the device kept dry?
• Is there no damage on the device?
• Are the casters not broken or caught by any foreign object?
Power Cord
• Is the power cord placed safe from people stepping on?
• Are the power cords not damaged? Is power-line not exposed? Is the power cords not frayed?
Supplies
• Are ECG clip electrodes and PCG sensor pads ready?
• Does the printer have enough toner and paper?
• Is paper loaded in the printer?
After turning the power on
Main Unit
• No smoke or abnormal smell?
• No abnormal noises?
Check the date and time setting
• Are the date and time correct?
If not, see page 93 to set the correct date and time.
Warning
Do not install or store the device in a location where water or chemicals may splash on
the device. Electric shock may result.
Caution
Do not install in a location where the temperature or humidity is outside the allowed
range. This may cause malfunctioning or device failure.
BP-203RPE3(A).fm 19 ページ ９年月６日 土曜日 午後５時４分
To Next Page
Loading...
Need help?
General
