130
5-4. Changing the Arm Position
7. Push the arm in so that metal screw (2) on the arm
will face out, and tighten screw (3).
8. Loosen the screw (4) and slide the arm rail off.
9. Remove the fastener (5) for the PCG sensor cable.
10.Change the PCG sensor cable so that it faces out,
and move the PCG sensor pocket to the outer side.
11. Attach the arm rail and PCG sensor cable fastener
(5), and tighten screw (4).
BP-203RPE3(A).fm 130 ページ ９年月６日 土曜日 午後５時４分
To Next Page
Loading...
