252
Pulse Outputs Section 5-3
Output Pattern The output pattern for S-curve acceleration/deceleration is shown below.
Example for PLS2(887)
The same type of S-curve acceleration/deceleration can be used for
ACC(888) as well.
Note The curve for S-curve acceleration/deceleration is formed by applying a cubic
equation to the straight line of the set acceleration/deceleration rates (a cubic
polynomial approximation). The curve’s parameters cannot be changed.
The maximum acceleration will be 1.5 times that of trapezoidal acceleration/
deceleration for the same acceleration/deceleration rate.
Stop frequenc
Time
Starting
frequency
Target
frequency
Pulse frequency
Set
acceleration
Specified
number of
pulses
PLS2
executed
Target frequency
reached
Deceleration point
Set
deceleration
Output stops
Acceleration
specified
for S-curve
acceleration
Deceleration
specified
for S-curve
deceleration
Max. acceleration
is 1.5 times
set acceleration
To Next Page
Loading...
