560
Installation and Initial Setup Section 9-8
9-8-3 Network Installation
Basic Installation Precautions
• Take the greatest care when installing the Ethernet System, being sure to
follow ISO 802-3 specifications. You must obtain a copy of these specifi-
cations and be sure you understand them before attempting to install an
Ethernet System. Unless you are already experienced in installing com-
munications systems, we strongly recommend that you employ a profes-
sional to install your system.
• Do not install Ethernet equipment near sources of noise. If noise-prone
environments are unavoidable, be sure to take adequate measures
against noise interference, such as installing network components in
grounded metal cases, using optical links in the system, etc.
Recommended products
The following products are recommended for use with the Ethernet Option
Board.
Part Maker
Model
number
Specifications Inquires
Hub 100BASE-TX
OMRON W4S1-03B 10/100 Mbit/s 3-port hub
OMRON W4S1-05B
(C)
10/100 Mbit/s 5-port hub
PHOE-
NIX CON-
TAC T
SWITCH
5TX
10/100 Mbit/s 5-port hub
Allied
Tele si s
RH509E 9-port hub Allied Telesis
(0120) 86-0442
(in Japan only)
MR820TLX 9-port hub with 10Base-5
backbone port
10BASE-T
Allied
Tele si s
RH509E 9-port hub Allied Telesis
(0120) 86-0442
(in Japan only)
MR820TLX 9-port hub with 10Base-5
backbone port
Twisted-pair
cable
100BASE-TX
Fujikura F-LINK-E
0.5mm x 4P
STP (shielded twisted-
pair) cable: Category 5, 5e
Note: Impedance is lim-
ited to 100 Ω.
---
Fujikura CTP-LAN5
0.5mm x 4P
UTP (unshielded twisted-
pair) cable: Category 5, 5e
10BASE-T
Fujikura F-LINK-E
0.5mm x 4P
STP (shielded twisted-
pair) cable: Category 3, 4,
5, 5e
Note: Impedance is lim-
ited to 100 Ω.
Fujikura CTP-LAN5
0.5mm x 4P
UTP (unshielded twisted-
pair) cable: Category 3, 4,
5, 5e
Connectors
(Modular
plug)
STP Plug
Panduit
Corp
MPS588 ---
UTP Plug
Panduit
Corp
MP588-C ---
To Next Page
Loading...
