289
Pulse Outputs Section 5-3
• The frequency can be changed. (The target frequency can even be
changed during acceleration or deceleration.)
• The acceleration/deceleration rate can be changed. (The rate can
even be changed during acceleration or deceleration.)
• The output mode and direction cannot be switched.
(6) ACC(888) (Independent) to PLS2(887)
• The number of pulses can be changed. (The setting can even be
changed during acceleration or deceleration.)
• The frequency can be changed. (The target frequency can even be
changed during acceleration or deceleration.)
• The acceleration/deceleration rate can be changed. (The rate can
even be changed during acceleration or deceleration.)
• The output mode and direction cannot be switched.
(7) ACC(888) (Continuous) to PLS2(887)
• The frequency can be changed. (The target frequency can even be
changed during acceleration or deceleration.)
• The acceleration/deceleration rate can be changed. (The rate can
even be changed during acceleration or deceleration.)
• The output mode and direction cannot be switched.
(8) PLS2(887) to PLS2(887)
• The number of pulses can be changed. (The setting can even be
changed during acceleration or deceleration.)
• The frequency can be changed. (The target frequency can even be
changed during acceleration or deceleration.)
• The acceleration/deceleration rate can be changed. (The rate can
even be changed during acceleration or deceleration.)
• The output mode and direction cannot be switched.
To Next Page
Loading...
