458
Temperature Sensor Units Section 7-5
7-5-2 CP1W-TS003 Temperature Sensor Units
CP1W-TS003 Temperature Sensor Unit provides up to four input points.
The inputs can be from thermocouples or analog inputs.
CP1W-TS003 Temperature Sensor Unit is allocated four input words, so no
more than three Units can be connected.
Part Names
Temperature Sensor Units:
CP1W-TS003
(1) Temperature Sensor Input Terminals
Used to connect temperature sensors such as thermocouples or analog
inputs.
(2) DIP Switch
Used to set the input type (temperature or analog input), the input ther-
mocouple type (K or J) and the temperature unit (°C or °F). Make the set-
ting according to the specifications of the temperature sensors or analog
inputs that are connected.
(3) Expansion I/O Connecting Cable
Connected to the expansion connector of a CP1H CPU Unit or a CP-
series Expansion Unit or Expansion I/O Unit.The cable is included with
the Temperature Sensor Unit and cannot be removed.
Note Do not touch the cables during operation. Static electricity may
cause operating errors.
(4) Expansion Connector
Used for connecting CP-series Expansion Units or Expansion I/O Units.
(4) Expansion Connector
(1) Temperature Sensor or Analog Input Terminals
(Terminal block is not removable)
(3) Expansion I/O
Connector Cable
(2) DIP Switch
To Next Page
Loading...
