570
Memory Allocations Section 9-9
FINS/
TCP Port Settings
FINS/TCP Connection
No.1 to 2
Each FINS/TCP connection number has 5 bytes. The configuration of the 5
bytes of data in each number is as shown in the following diagram.
HTTP Server Setup
If the password for accessing the Ethernet Option Board’s Web page is forgot-
ten, find out it in this area. It is written in ASCII format.
FINS Node Address
Using IP Address
Display/Setting Area
The IP address is (1)(2).(3)(4).(5)(6).(7)(8) (hex)
If the local IP address in the system setup is set to a value other than 0.0.0.0,
this area will act as an IP address display area and the local IP address in the
system setup will be read and stored here when the power is turned ON or the
Ethernet Option Board restarted.
n+138 000000
0
000 000 0
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Protect setting
(Connection No.1)
Protect setting
(Connection No.2)
Bit Settings Unit operation
0 Reserved Always 0.
1 Protect setting
0: The IP address of FINS/TCP connection No.1 is not
under the protection.
1: The IP address of FINS/TCP connection No.1 is under
the protection.
2 to 4 Reserved Always 0.
5 Protect setting
0: The IP address of FINS/TCP connection No.2 is not
under the protection.
1: The IP address of FINS/TCP connection No.2 is under
the protection.
6 to 15 Reserved
Always 0.
Destination IP address Auto-allocated
FINS node
Offset 15 8 7 0
n+149
HTTP Password
⋅⋅⋅
n+152
n+153 HTTP Port number
n+154
FINS node address (hex)
The setting range is 0~ FE (hex).
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
n+155
n+156
(1)(2) (3)(4)
(5)(6) (7)(8)
To Next Page
Loading...
