EasyManuals Logo

Omron CX-Supervisor Getting Started Guide

Omron CX-Supervisor
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Copy Protection SECTION 1 Introduction
7
512Mbyte of RAM.
650Mbyte available hard disk space.
1024 x 768 XGA display.
1-3-2 Operating Systems and Environments
The operating systems on which this software should be run are:
Microsoft Windows 2000 (SP2)
Microsoft Windows XP Professional
1-3-3 Interfaces to Hardware Communications
CX-Supervisor utilises communications driver CX-Server for direct
communication with OMRON factory automation equipment.
If it is intended for a PLC to be connected to the development computer for
executing program code and testing, one of the following is required:
RS-232C connection via a standard serial port on the computer (COM1
etc.)
RS-422 connection to a 422 serial board
Standard Ethernet board
Standard USB port
An OMRON Network Service Board
Refer to the appropriate hardware system manuals for full information about
connecting and configuring these devices for the environment.
1-4 Copy Protection
CX-Supervisor is copy protected to prevent illegal use. During installation a
valid License Key must be entered. The CX-Supervisor Runtime environment
has additional protection and if the protection is not installed certain features
are inaccessible. To gain access to these features the USB protection must be
installed.
1-4-1 Copy Protection using a USB Dongle
The Runtime copy protection method consists of a small box called a "Dongle"
which is plugged into a USB port. When CX-Supervisor is run the port is
checked for a valid dongle and the program fails if it is not present.
1-4-1-1 Fitting a CX-Supervisor USB Dongle
Simply connect the dongle to any spare USB port of the computer noting any
instructions supplied. If there are no spare sockets a "USB Hub" device may
be used to add extra sockets.
Once fitted, Windows will automatically detect the new hardware and the
power light on the USB Dongle will illuminate.
Note: This product does not install or run on Windows NT, Windows ME, Windows98
or Windows 95.
Note: CX-Supervisor is not guaranteed to be compatible with computers running
Windows emulation (e.g. Apple Macintosh or VMWare).
Note: Internet Explorer 5.0 or later is required to use the version of CX-Server
installed with this product

Other manuals for Omron CX-Supervisor

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron CX-Supervisor and is the answer not in the manual?

Omron CX-Supervisor Specifications

General IconGeneral
BrandOmron
ModelCX-Supervisor
CategorySoftware
LanguageEnglish

Related product manuals