Omron E5AN User Manual

220
Advanced Function Setting Level Section 5-8
• This parameter returns all parameter settings to their defaults.
• After the initialization, the set value automatically turns off.
This parameter enables switching between set points 0 to 3 by operating the
keys on the front panel.
Prerequisites
• A model without event inputs
• The Number of Multi-SP Uses parameter set to 0 on a model with event
inputs
on: Set points 0 to 3 can be selected.
off: Set points 0 to 3 cannot be selected.
• Default: OFF
■ Related Parameters
Multi-SP set point setting (operation level): Page 167
Number of multi-SP uses (Initial setting level): Page 213
• This parameter sets the time unit for the rate of change during SP ramp
operation.
■ Related Parameters
Ramp SP monitor (operation level): Page 167
SP ramp set value (adjustment level): Page 193
init Parameter Initialization
Setting range Default
off: Initialization is not executed. off
fact: Initializes to the factory settings described in the manual.
Function
Setting
mspu Multi-SP Uses
The model must not support event
inputs, or the number of multi-SP
uses must be 0.
Function
Setting
See
See
spru SP Ramp Time Unit
The ST parameter must be set to
OFF.
Setting range Default
s: EU/s, m: EU/min, h: EU/h m
Function
Setting
See
See

Omron E5AN Specifications

General

Brand	Omron
Model	E5AN
Category	Temperature Controller
Language	English