Omron E5AN

252
Advanced Function Setting Level Section 5-8
• This parameter monitors the number of times that control output 1 is
turned ON and OFF.
• This function is not displayed when the set value is 0, or when the control
output is a linear output.
• This parameter monitors the number of times that control output 2 is
turned ON and OFF.
• This function is not displayed when the set value is 0, or when the control
output is a linear output.
ra1m Control Output 1 ON/OFF Count Monitor
Control output 1 must be supported.
Relay or voltage outputs (for driving
SSR) must be used.
The Control Output 1 ON/OFF Count
Alarm Set Value parameter must not
be set to 0.
Monitor range Unit
0 to 9999 100 times
Function
Monitor
ra2m Control Output 2 ON/OFF Count Monitor
Control output 2 must be supported.
Relay or voltage outputs (for driving
SSR) must be used.
The Control Output 2 ON/OFF Count
Alarm Set Value parameter must not
be set to 0.
Monitor range Unit
0 to 9999 100 times
Function
Monitor