Omron E5CC-T User Manual

5 Advanced Operations
5 - 94
E5@C-T Digital Temperature Controllers User’s Manual (H185)
This section describes the parameters that are displayed on each tab page.
z Basic Tab Page
Use this tab page to set the parameters that are used by all programs.
o
Parameter Tab Pages
Parameter name Description Controller Setting Level Page
Program Time Unit
This parameter sets the time unit for the
program.
Initial Setting Level 6-58
Step Time/Ramp Rate
Programming (Rate of
Rise Programming)
This parameter specifies the segment
setting method when a program is set.
Initial Setting Level 6-59
Time Unit of Ramp
Rate
This parameter sets the time unit for the
denominator of the Segment Slope
parameter.
Initial Setting Level 6-59
Program End ON Time
This parameter sets the pulse width of the
program end output.
Advanced Function
Setting Level
6-82
Program SP Shift
Value
This parameter performs a fixed-rate
compensation (1-point compensation) for
the program SP (PSP).
Adjustment Level 6-35
Standby Time Unit
This parameter sets the unit for the
standby time.
Advanced Function
Setting Level
6-82
Standby Time
This parameter is used to set the time
from when the run command is executed
until the program starts operation.
Adjustment Level 6-34
Program Number
This parameter specifies the program
number to use to start program operation.
Operation Level 6-10
PV Start
This parameter is used to set the method
for starting the program.
Initial Setting Level 6-62
Operation End
Operation
This parameter is used to specify the
operation status after the program has
been completed.
Initial Setting Level 6-61

Omron E5CC-T Specifications

General

Brand	Omron
Model	E5CC-T
Category	Temperature Controller
Language	English