What to do if the NS indicator remains lit green and status does not change on Omron ERT1?
If the NS indicator remains lit green and status does not change on your Omron Network Hardware: - Check that the Master Unit is operating correctly. - Check that the tag data links are set correctly. - Reset the tag data links.
What to do if the NS indicator remains not lit and status does not change on Omron ERT1?
If the NS indicator remains not lit and status does not change on your Omron Network Hardware: - Check that all Slave Unit connectors are connected correctly. - Check that the Master Unit is operating correctly. - If using an OMRON Master Unit, check the Master Unit mode and the Slave Unit node addresses. - Check that the communications cable is wired correctly. - Check that the power supply cable and power supply are wired correctly and that the settings are correct. - Check connector wiring to make sure that the communications cable and power supply cables are not disconnected.
General| Product Series | ERT1 Series |
|---|---|
| Category | Network Hardware |
| Type | Remote I/O Terminal |
| Communication Protocol | EtherCAT |
| Power Supply | 24 VDC |
| Mounting | DIN Rail |
| Digital I/O | Available |
| Analog I/O | Available |
| Number of I/O Points | Varies by model |
| Input Voltage | 24 VDC |
| Operating Temperature | -10°C to 55°C |
| Storage Temperature | -25°C to 65°C |
| Humidity | 25% to 85% (with no condensation) |
| Weight | Varies by model |
To Next Page