Omron fh series - 5 How to Start the Setup Program

28
5. How to Start the Setup Program
This chapter describes how to start the setup program. To set the robot vision of
the Vision Sensor, the setup program must be running on the robot side. Establish
the connection between the Vision Sensor and the robot controller by [3. Connecting
Vision Sensor to Robot Controller]
1
(Operation of TMflow)
Like shown on the right figure,
On the project editing screen,
click the icon.
Select [FHSETUPMAIN] from
the list of projects and click
[OK]
to load the setup
program.
2
(Operation of Robot Stick)
Press the [Play/Pause] button
on the robot stick to run the
project.
When the project is in the
running state, the robot's ring
will flash green.