Omron H5S - Setting (Temporary) Holidays 31

- 34 -
Clearing the holiday settings
<Clearing a part of holiday settings>
When the holiday to be cleared is displayed,
give a short press on .
Press to clear the holiday
setting.
If is pressed while "clr" is flashing,
clearing operation is cancelled.
<Clearing all holiday settings>
When any of the holiday settings is displayed,
press for 3 s or more.
Press to clear all the holiday
settings.
If is pressed while "clr" is flashing,
clearing operation is cancelled.
A display in run mode
On a day set as a holiday, the " "
indicator is lit.
Note
• Any date between the current date and December 31 in the year after the
following year can be specified as a holiday.
• The setting is automatically cleared after passing the dates set as holidays
(unless the year is set to --).
• If multiple settings are required, repeat the steps
through .
• Both the start and end dates of holidays must be set. The maximum number of
holidays that can be set is 16.
• Holiday setting mode can be entered from run mode only.
• If the current date setting is changed, all holiday settings will be cleared.
•
• If no Key input is entered within 30 s or if is pressed again for 2 s or
more, the display automatically returns to run mode.
HOLIDAY
SUN MON TUE WED THU FRI SAT
CLEAR
CLEAR
CLEAR
CLEAR
WRITE
WRITE